Problem
Possible cause
Solution
The room temperature is
too high.
Refer to climate class chart on
the rating plate.
Food products placed in
the appliance were too
warm.
Allow food products to cool to
room temperature before stor-
ing.
The FROSTMATIC function
is switched on.
Refer to "FROSTMATIC func-
tion".
The compressor does not
start immediately after
pressing the FROSTMATIC
or after changing the tem-
perature.
This is normal, no error has
occurred.
The compressor starts after
some time.
Water flows on the floor.
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
Attach the melting water out-
let to the evaporative tray.
Temperature cannot be set. The FROSTMATIC or
COOLMATIC function is
switched on.
Switch off FROSTMATIC or
COOLMATIC manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FROSTMATIC
or COOLMATIC function".
The temperature in the ap-
pliance is too low/too high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera-
ture.
The food products temper-
ature is too high.
Let the food products temper-
ature decrease to room tem-
perature before storage.
The FROSTMATIC function
is switched on.
Refer to "FROSTMATIC func-
tion".
Door does not open easily.
You attempted to re-open
the door immediately after
closing.
Wait a few seconds between
closing and re-opening of the
door.
If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.
7.
INSTALLATION
WARNING!
Refer to Safety chapters.
7.1
Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
ENGLISH
9
