–
Remove after the appliance is suf-
ficiently cool:
limescale rings , wa-
ter rings, fat stains, shiny metallic
discolorations. Use a special clean-
ing agent for glass ceramic.
• The surface of the hob has horizontal
grooves. Clean the appliance with a
moist cloth and some detergent with a
smooth movement
from left to right.
• At the end
rub the appliance dry
with a clean cloth
.
7.
TROUBLESHOOTING
Problem
Possible cause
Remedy
You cannot activate the
appliance or operate it.
Activate the appliance
again and set the heat
setting in less than 10
seconds.
You touched 2 or more
sensor fields at the same
time.
Touch only one sensor
field.
The STOP+GO function
operates.
Refer to the chapter
“Daily Use”.
There is water or fat
stains on the control
panel.
Clean the control panel.
An acoustic signal
sounds and the appli-
ance deactivates.
An acoustic signal
sounds when the appli-
ance is deactivated.
You put something on
one or more sensor
fields.
Remove the object from
the sensor fields.
The residual heat indica-
tor does not change col-
ours.
The cooking zone is not
hot because it operated
only for a short time.
If the cooking zone oper-
ated sufficiently long to
be hot, speak to the
service centre.
The Automatic Heat Up
function does not oper-
ate.
The cooking zone is hot.
Let the cooking zone be-
come sufficiently cool.
The highest heat setting
is set.
The highest heat setting
has the same power as
the Automatic Heat Up
function.
The heat setting changes
between two levels.
The Power management
is activated.
Refer to “Power man-
agement”.
The sensor fields be-
come hot.
The cookware is too
large or you put it too
near to the controls.
Put large cookware on
the rear cooking zones if
necessary.
ENGLISH
13
Summary of Contents for 949 595 048 00
Page 74: ...74 www aeg com ...
Page 75: ...ESPAÑOL 75 ...