AEG 6230262, Original Instructions Manual, Page: 18 / 20

GB
SPECIFIED CONDITIONS OF USE
This jig saw is intended to cut wood, plastic and metal; it can cut
straight lines, bevels, curves, and internal cut-outs.
Do not use this product in any other way as stated for normal use.
MAINS CONNECTION
Connect only to single-phase AC system voltage as indicated on
the rating plate. It is also possible to connect to sockets without an
earthing contact as the design conforms to safety class II.
It is recommended that this tool is always supplied via a residual
current device with a rated residual current of 30mA or less.
Before doing any work on the machine, pull the plug out of the
socket.
Only plug-in when machine is switched off .
Keep mains lead clear from working range of the machine. Always
lead the cable away behind you.
Do not let any metal parts enter the airing slots - danger of short
circuit!
Under the eff ect of extreme electromagnetic interferences from
the outside, temporary variations in the speed of rotation could
arise in particular cases.
MAINTENANCE
The ventilation slots of the machine must be kept clear at all times.
If the supply cord of this appliance is damaged, it must only be
replaced by a repair shop appointed by the manufacturer, to avoid
hazardous situations.
Use only AEG accessories and spare parts. Should components
need to be replaced which have not been described, please contact
one of our AEG service agents (see our list of guarantee/service
addresses).
If needed, an exploded view of the tool can be ordered. Please state
the machine type printed as well as the six-digit No. on the label
and order the drawing at your local service agents or directly at:
SYMBOLS
Please read the instructions carefully before starting the
machine.
Always wear goggles when using the machine.
Wear gloves!
CAUTION! WARNING! DANGER!
Always disconnect the plug from the socket before
carrying out any work on the machine.
Accessory - Not included in standard equipment, available
as an accessory.
Do not dispose of electric tools together with household waste
material. Electric tools and electronic equipment that have
reached the end of their life must be collected separately and
returned to an environmentally compatible recycling facility.
Check with your local authority or retailer for recycling advice
and collection point.
Class II tool Tool in which protection against electric
shock does not rely on basic insulation only, but in which
additional safety precautions, such as double insulation or
reinforced insulation, are provided. There being no provi-
sion for protective earthing or reliance upon installation
conditions.
Techtronic Industries (Australia) Pty. Ltd.
PO Box 1065
Mount Waverley VIC 3149
Tel. no. 1300 361 505
Australia
Techtronic Industries N.Z. Ltd.
PO Box 12-806
Penrose AUCKLAND 1642
Tel no. 0800 279 624
New Zealand
Regulatory Compliance mark (RCM).
This product meets applicable regulatory requirements.
M aterial s made of aluminium .
M aterial made of wood .
1
9
S ynthetic material Perspex®, in German Plexiglas®, which is
transparent , high-impact-resistant glass .
Materials made of metal (metal sheets pipes, corrugated sheet).
16