36
tEstING tHE opErAtIoN of tHE GAs cookEr
NOTE: You MUST test the cooker after installation,
before you hand it over to the customer. You MUST
have a manometer and a connecting tube.
checking gas supply
1 . turn on the gas supply and the electricity and try to
ignite the gas .
NOTE: It will take additional time to light the gas for
the first time as air needs to be purged from the pipes.
testing the cooker features
• Observe the flame appearance on each burner. If
it is much smaller or larger than expected, then the
injector size needs checking .
NOTE: When flame is unsatisfactory, then refer to the
Electrolux Technical Publications and correct the fault,
if possible.
when maximum flame appearance is correct, then
check the turn-down setting on each burner . If the
settings appear to be incorrect, proceed as follows:
1 . adjust the bypass screw mounted on the body of
each hotplate control cock . this is accessible when
the control knob and the control panel are removed .
2 . check the ignition on all burners both separately
and in combination .
3 . check the operation of the electrical components,
if applicable .
4 . If you are satisfied that the cooker is operating
correctly, then turn it off and show the customer how
to use it . Make sure you ask the customer to operate
the clock and controls .
NOTE: If the cooker cannot be adjusted to perform
correctly, then inform the customer of the problem and
put a warning notice on the cooker. If the problem is
dangerous, then disconnect the cooker. If there is a
fault, then the customer should be advised to contact
the manufacturer’s local service organisation.
