--------------------------------------------------------------------------------11/13--------------------------------------------------------------------------------
5
Antennas
The following antennas are suitable for this reader:
a) high power plate antenna AAN FK6 (only choice for USA)
b) high power plate antenna AAN FK2 / FK3
c) rod antenna
AAN FK0
The reader with above antennas was tested against the requirements according
ETS 300683 and EN 55022 class B.
It is possible that antennas of other manufacturers may fit to the device. However, if connecting such non orig-
inal manufacturer antennas to the device, the warranty will get lost. Also a separate operation permission by
the local state administration might be required.
Special models
The standard device is equipped with an RS 232 interface.
On request there are special models available which support the interface with one of the following interfaces
instead of the RS 232:
-
- Interbus S
- Profibus DP
- CAN
- RS485
6
Warnings and cautions
When using the original AEG ID antennas suited for that device, the combination of antenna and reader have
the German permission for operation. Please check, if special permissions are required at the place of opera-
tion.
This reader is an active electrical transmission system and radiates in the frequency range of approximately
124 kHz. When connecting a defect or a not suited antenna to the device the radiated power can be higher
than 42dBµA/m (measured at 10 m distance). The operator is responsible that people at risk are not end-
agered by the device.
Do not operate the device with open housing, as otherwise there is a danger, that positions with dangerous volt-
age can be touched.
Never operate the device with defect antenna cables. The antenna cables may conduct dangerous voltages.
When disconnecting an antenna cable please assure that the device is turned off and the cable was groundes for
a short time before touching it. Otherwise stored energy of the antenna may cause harm.
The device should only be opened by trained personal when switched off.
Caution!
Never mount or place the antenna on extended metal parts. Do not bring another antenna very near at the
operated antenna (second antenna operated or not). In both cases there is a risk, that the antenna may be
destroyed. Such defects are not covered by the warranty.
