22
Changing bulb for inside light
Only use a special bulb which is designed specially for dryers. The spe-
cial bulb is available from the after-sales service,
ET-Nr. 112 552 000-5.
1
Warning!
Do not use standard bulbs! These develop too much heat and
may damage the machine!
1
Warning!
Before replacing the bulb, disconnect the mains plug; with a
permanent connection: fully unscrew or deactivate the fuse.
1.
Unscrew covering bonnet from above bulb (this can be found directly
behind the loading aperture, at the top; refer to “Description of ma-
chine” section.)
2.
Replace defective bulb.
3.
Screw covering bonnet back down.
1
Warning!
For reasons associated with safety, the covering bonnet must
be screwed down tightly. If this is not done, the dryer must not be op-
erated.
Drying cycle lasts an
unusually long time.
Note:
After up to 5 hours the
drying cycle finishes
automatically
(see ”Drying cycle
complete”).
Lint filter clogged.
Clean lint filter.
Heat exchanger clogged
with lint.
Clean heat exchanger.
SPECIAL CARE (SCHON) but-
ton pressed and load vol-
ume too big.
SPECIAL CARE (SCHON) is only
suitable for use with loads of
up to 3kg!
Load volume too big.
Reduce load volume.
Laundry insufficiently pre-
drained.
Laundry must be adequately
pre-drained.
Problem
Possible cause
Remedy
