Water drainage
This appliance is designed to be permanently plumbed into your home's drainage system
using one of the following methods.
1.
Into a drainage standpipe
Firstly form a hook in the end of the drain
hose using the “U” piece” supplied.
Place the drain hose into your standpipe,
which should have an internal diameter of
approximately 38 mm thus ensuring there
is an air break between the drain hose and
standpipe.
When discharging into a standpipe ensure
that the top of the standpipe is no more
than 90 cm (35.4'') and no less than 60 cm
(23.6'') above floor level.
The drain hose may be extended to a max
-
imum of 4 metres. An additional drain
hose and joining piece is available from
your local Service Force Centre. The joining piece must have an internal diameter of 18
mm.
If your drain hose looks like this (see be
-
low) you do not require the “U” piece”. Just
push the hose firmly in to the standpipe.
2.
Onto a sink outlet spigot.
If the outlet spigot has not been used be
-
fore, remove any blanking plug that may
be in place.
38 mm (11.2”)
standpipe
diameter
30 cm(12”)
32
Installation
Summary of Contents for Lavamat 64840L
Page 1: ...LAVAMAT 64840L 66840L User manual Washing Machine...
Page 35: ...35...
