What to do if…
32
Malfunction
Possible cause
Remedy
1 short warning tone
, con
tinuously repeated, can be
heard,
the cycle indicator for the se
lected dishwashing cycle is
flashing:
the
control indicator
lights up:
fault code
Å 10
is displayed
in the multidisplay:
(Problems with water inlet)
Water tap is blocked with
limescale or faulty.
Check the water tap and have it
repaired if necessary.
The tap is turned off.
Turn the tap on.
The filter (where present) in the
threaded hose fitting on the
tap is blocked.
Clean the filter in the threaded
hose fitting.
Filters in the base of the dish
washer compartment are
blocked.
Cancel the dishwashing cycle
(see chapter: Starting a dish
washing cycle),
clean filters (see chapter:
Cleaning the filters),
then start the dishwashing cy
cle again.
Water inlet hose
has not been correctly posi
tioned.
Check the position of the hose.
2 short warning tones
, con
tinuously repeated, can be
heard,
the cycle indicator for the se
lected dishwashing cycle is
flashing,
fault code
Å 20
is displayed
in the multidisplay. (Prob
lems with water outflow)
The sink outlet is blocked.
Clean out sink outlet.
Water drain hose
has not been correctly posi
tioned.
Check the position of the hose.
3 short warning tones
, con
tinuously repeated, can be
heard,
Fault code
Å 30
is displayed
in the multidisplay.
The antiflood system has been
triggered.
First shut off the water tap,
then switch off the appliance
and contact the Customer Care
Department.
1 long warning tone
can be
heard,
The
control indica
tor is lit.
The upper basket spray arm is
jammed.
Open the door
carefully
Hot steam may escape when
the door is opened. There is a
risk of scalding. Arrange the
dishes and cutlery in the bas
kets so that the spray arm
above can rotate freely. Close
the dishwasher door.
The
control indicator is
lit.
The door of the dishwasher is
open.
Close the dishwasher door.
