16
INSTALLATION
lf this appliance featuring magnetic door seals is
to replace an older appliance having a spring
lock (latch) on the door or lid, be sure to make
that spring lock unusable before you discard the
old appliance. This will prevent it from becoming
a death-trap for a child.
Positioning
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
Best performance is obtained with ambient
temperature b18°C and +43°C (class T);
+18°C and +38°C (class ST); +16°C and +32°C
(class N); +10°C and +32°C (class SN). The class of
your appliance is shown on its rating plate.
For safety reasons, minimum ventilation must be as
shown in Fig.:
Appliance positioned under overhanging kitchen wall
units (see Fig.-A).
Appliance positioned without overhanging kitchen
units (see Fig.-B).
Attention: keep ventilation openings clear of
obstruction.
Two adjustable feet at the cabinet base allow
accurate levelling of the appliance.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply. Voltage
can vary by +6% of the rated voltage. For operation
with different voltages, a suitably sized auto-
transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a
contact for this purpose.
If the domestic power supply socket is not
earthed, connect the appliance to a separate
earth in compliance with current regulations,
consulting a specialist technician.
The Manufacturer declines all responsibility if the
above safety precautions are not observed.
This appliance complies with EEC directive
number 87/ 308 of 2/6/87 relative to radio
interference suppression.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Door reversibility
Before carrying out the operations described below,
pull out the mains plug from the wall socket.
Proceed as follows:
1. Remove bottom hinge (5).
2. Remove door (4).
3. Unscrew pin (2) from the top hinge (1) and refit it
on the opposite side.
4. Unscrew part (6) and refit it on the opposite side.
5. Refit the door and the bottom hinge on the
opposite side.
6. Remove handle (3) and refit it on the opposite side.
The holes that are not used are to be masked with
the plastic plugs removed.
100 mm
10 mm
10 mm
A
B
NP006
