V1.02017EN
Soldering
Depending on your use, you will have to solder wires/cable corresponding to the characteristics
of the device on which you want to display the camera stream.
The two solder pads (video & GND) are easily identifiable.
*CAUTION : Over-heating the interface can damage the PCB or components.
Tips & Tricks :
Description
How to solve
E1 back LCD screen is black
This is normal when the CVBS output is activated because the
video stream is sent to the AV interface. To get the image back on
the camera LCD, power off the E1, unplug the AV interface &
power On the E1 again
I no longer have the video stream
with AV Interface
Each time you use the E1 without the AV interface, the CVBS
output will automatically turn off. Just power cycle the camera with
the interface plugged in, and re-activate ‘CVBS out’ in the menu
The video stream is frozen on my
external monitor
This occurs when the E1 is not used and switches to standby
mode. To wake up the monitor, take a picture or start/stop a video.
To avoid this, you can disable the ‘Auto off panel’ (Settings > Setup
Menu > Auto off panel > Set to : Manual)
www.aedrox.com
5
