AED Audio - MULTI12 - User manual
7
TRANSPORTATION, HANDLING AND COMMISSIONING
INSTALLATION
TRANSPORTATION
REMOVE THE SHIPPING ASSEMBLY
ATTENTION
Keep the product dry and the temperature between 0°C and 30°C to avoid damage to the speaker. Please always
handle with care.
Before unpacking the fixture, please make sure that the packaging is in good condition and that following items will
be found in the box:
Installation overhead needs a high level of experience. This includes (but is not just limited to) calculation and defini-
tion of load capacity, used installation material and regular safety inspections of used material and the fixture itself.
Never try to do the installation by yourself if you are not qualified, instead you have to instruct a skilled installer.
Inappropriate installations can cause injuries and/or damage of property.
Remove the tape from the box and open the box. Take the unit out and remove the plastic foil around the unit. Make
a visual inspection of the unit. Please check condition of units while unpacking, if any damages occur, the unit must
be repaired/replaced before it can be used. Please contact your local distributor for service. If units are damaged and
still used, AED Audio cannot be held liable for any risk/danger or occurrence given by these damaged units.
There are specific regulations like BGV C1 (old VBG 70) or country related regulations which need to attend during the
installation. The installation has to be handled by skilled persons only!
Suspension device has to be built and calculated in order to handle up to 10 times its specific load limit over a time of
one hour without permanent or harmful deformation.
Installation has to be done with a separate, independent suspension device like a safety chain.
Trespassing the danger zone below the installation during the assembling is prohibited.
Installer has to take care of all safety and machinery installations are approved by authorized persons before first
operation or after changes before restarting.
Installer has to take care of all safety and machinery installations are approved by skilled persons at least once a year.
Installer has to take care of all safety and machinery installations are approved by authorized persons every four years
during the acceptance inspection. Spotlight should ideally installed outside peoples lounge area.
1x MULTI12
1x Safety instructions
CAUTION: Mounting place must be sufficient stable and be able to support a weight of 10 times of the unit’s
weight.
CAUTION: Assure the specified safety distances to flammable material.
