7. POWERING ON
Connect to the desired input voltage and press
and hold the on/off button for 2-3 seconds to
turn the unit on, the display will show the current
internal fridge temperature.
8. ADJUSTING THE TEMPERATURE
The temperature controller provides the ability to set the desired temperature level and displays
information on the fridge and set temperature.
The controller has been programmed to maintain an average of the set temperature. The
compressor will start up when the internal temperature increases 0.5 to 1.5 degrees above
the selected temperature and will run until the temperature is 0.5 to 1.5 degrees below the set
temperature.
When your appliance is first connected to the
AC or DC input the digital readout will show the
current temperature – the temperature shown
on the “LEFT ZONE TEMP” display corresponds
to the larger left zone compartment, the
temperature on the “RIGHT ZONE TEMP”display
corresponds to the stepped right zone
compartment.
To increase fridge temperature press “up”
▲
and to decrease press “down”
▼
until the
desired temperature is achieved. Once selected
the display will flash a number of times before
returning to the current temperature.
NOTE: The left bin can only be set to an equal
or higher temperature than the right bin.
9. MAX/MIN FUNCTION
This function allows the compressor speed to be slowed down to increase operating efficiencies
(MIN) or increase the compressor speed to provide “quick” cool down time (MAX).
To operate press the button to commence the “economy” operation mode, the MIN indicator
will illuminate.
Press the button again to select the MAX operating mode. The MAX indicator red light will
illuminate.
7
