Installation:
Removal of the Radio control center is required for installation. Vehicle Specific instructions are available on-line at www.
voxxuniversity.com.
After the components are removed, connect the following:
1. The navigation module can be located behind the radio or to either side.
In some vehicles it may be located below the radio. We have included a
extension Video (LVDS) cable for these cases. Determine your exact
mounting location to insure you route your wires correctly.
2. Remove the Blue Video Cable and the Black power harness connection
from the rear of the panel housing.
3. Using the supplied power harness cable, plug into the OEM panel and
connect to the OEM cable. Plug the supplied Video cable in to the panel
and the factory cable into the Nav module video connection.
NOTE:
The panel may look different than the picture above but the connections are the same.
4. Connect the CAN module to the power harness connection.
5. Connect the CAN to Nav interface cable to the main Nav module as shown in the wiring diagram.
6. The white wire on the CAN module must be connected to the CAN wiring
behind the main radio chassis. Remove the radio chassis / CD player by
removing 4 screws. Once it is out of the dash you will connect the white CAN
wire to the Dark Green CAN wire shown here. This will allow access of the
NAV through the SWC switch, supply Reverse gear notification for a camera,
and Parking line information when using a add-on camera.
(Will not show parking line info on the OEM camera).
7.
External Speaker:
The system utilizes an external speaker for Nav Audio. Select a location to mount the speaker where it can
be clearly heard by the driver. Some suggestions are below the dash or the center console base.
•
If needed or for custom installation this can be wired to any standard 4 ohm speaker.
The Nav module has the ability to add a backup camera and 2 AV inputs. The module will support the factory backup camera if the
vehicle is equipped with this.
8.
Aux Video:
There are 3 RCA video inputs on the Nav Module. If these are used you must switch on the DIP switch that
corresponds to that input.
9.
Aux Audio:
Use the included harness for Audio in and Out.
10.
USB Update Cable:
This is used for map updates. Route the cable from the
module to the glove box for future use as needed. Connect to the Nav
module.
11.
GPS Antenna:
The antenna must be mounted in a location where it has a
clear view of the sky. Center of the dash by the glass is recommended.
NOTE:
If reception is poor re-locate to another area and re-test. The GPS antenna cannot be blocked by metal surfaces
and should be visible for best reception.
2
