6
d)
Drill a 5/8 inch hole at the selected location.
e)
Coat the edge of the hole with rust preventative.
f)
Route the camera cable through the grommet and then through
the hole.
g)
Insert the grommet in the hole to keep water from entering the
vehicle.
Flush Mounted Mounting Instructions
1.
Assembly the camera. Ensure that the spacer ring is installed before
the flush mounting supporter is screwed on.
2.
Find a suitable location on the bumper (preferably in the center)
where there is enough space behind the bumper for the camera.
3.
Verify that the planned mounting location is accessible from behind
and that you have access to route the wiring inside the vehicle.
4.
Drill a 1” Diameter hole in the bumper and mount the camera. Use
the alignment arrow and “UP” text to ensure the camera is mounted
upright and level.
5.
Be sure the press the camera in around the edges. Do not press
directly on the lens.
6.
Route the camera wiring into the vehicle.
When choosing a wiring
path, make sure the cable will not be damaged or pinched, as this
may cause a short circuit that is not covered by the warranty.
