7. CAN DIP Settings:
DIP Down= ON DIP UP= OFF
DIP
ON
OFF
Default
1
Front Camera
will
be shown after
Turn Signals are triggered and
Reverse gear is disengaged.
Front Camera
will Not
be shown
after Turn Signals are triggered.
Only
Shown after Reverse gear
is disengaged.
DOWN(ON)
2
No function
No function
UP(OFF)
3
No function
No function
UP(OFF)
4
No function
No function
UP(OFF)
8. Other Uses of Interface and their DIP settings:
In case interface is used only for adding only
Reverse Camera
or external
360 Surround View System
:
Interface Dip 1, 2, 3, 4 set to= UP (OFF)
Interface Dip 5 set to= DOWN (ON)
In case interface is used only for adding
Front Camera
and car is equipped with OE reverse camera:
Interface Dip 5 set to= UP (OFF) (This sets interface to show OE camera in reverse gear)
CAN Dip 1 set to= UP (OFF) (This sets interface to show Front camera when car is taken out of reverse
and put into drive)
In case interface is used for
Front, Right and Left Camera
and car is equipped with OE reverse camera:
Interface Dip 5 set to= UP (OFF) (This sets interface to show OE camera in reverse gear)
CAN Dip 1 set to= UP (OFF) (This sets interface to show Front camera when car is taken out of reverse
and put into drive)
Or
CAN Dip 1 set to= DOWN (ON) (If User desire to show front camera after turning off turn signals and
when taken out of reverse gear and put into drive)
*NOTE: All the cameras can be powered by the green wire [12V, Max 3A]. There will be power to the camera only in
the case of triggered state. In not triggered state it will carry 0V.
**NOTE: Incase the CAN code has changed in some car models(in some rare case) User can install the interface
without using the Power harness and connect the power directly to ACC and green wire given power separately for
triggering the camera's.
