- 23 -
www.advateklights.com
PixLite T8-S Mk2 User Manual V211013
seconds (after the controller is already running) or turn it on remotely from the “Test”
tab in the Advatek Assistant.
The controller will then enter the test pattern mode, where different test patterns are
available as described in the table below. The pattern will display the test pattern on
all pixels on each of the pixel outputs. Pressing the 'Test' button while in test mode will
move through each of the patterns successively in one continuous loop.
Test
Operation
Colour
Cycle
Outputs will cycle automatically through the red, green,
blue and white colours at fixed intervals. Pressing the but-
ton moves to the next mode.
Red
Solid Red
Green
Solid Green
Blue
Solid Blue
White
Solid White
Colour
Fade
Outputs will slowly move through a full continuous colour
fade. Pressing the button will loop back to the original col-
our cycle test mode.
To exit the test mode press and hold the ‘Test’ button down again for 3 seconds and
then release.
The hardware test requires that the pixel driver chip type and number of pixels per
output are set correctly in the Advatek Assistant. In this way you can test if that part of
your configuration is correct and isolate other possible problems with the incoming
Ethernet data side.
