27
UNO-1483G User Manual
Appendix A
S
ystem
Settings
and
Pin
A
ssignments
A.8
Clear CMOS (SW3)
This switch on the bottom of the board and is used to erase CMOS data and reset
system BIOS information.
Follow the procedures below to clear the CMOS.
1.
Turn off the system.
2.
Move the switch to PIN 2 to clear CMOS
3.
Move the switch back to PIN 1
4.
Turn on the system. The CMOS is now cleared.
5.
Turn on the system. The BIOS is reset to its default setting.
A.9
AT/ATX setup
To setup AT/ATX mode, enter into BIOS setup menu, [Chipset]->[Restore AC Power
Loss] options:
1.
Power On: AT mode
2.
Power off: ATX mode
Note!
An alternative method of clearing the CMOS data is to remove the RTC
battery.
Summary of Contents for UNO-1483G Series
Page 8: ...UNO 1483G User Manual viii...
Page 14: ...UNO 1483G User Manual 4...
Page 22: ...UNO 1483G User Manual 12...
Page 31: ...Appendix A A System Settings and Pin Assignments...
