Ordering Information
Part Number
Description
TREK-120-ANF000A00
Temperature/humidity/G sensor by NFC
TREK-120-ANLNA0A00
Temperature/humidity/G sensor by NFC+LoRa
NA902/TW922
TREK-120-ANLEU0A00
Temperature/humidity/G sensor by NFC+LoRa
EU868
TREK-120-ANLCN0A00
Temperature/humidity/G sensor by NFC+LoRa
CN470
TREK-120-ANR000A00
Cold Chain NFC reader
TREK-120-ALG000A00
LoRa gateway dongle 525MHz ~ 928MHz
TREK-120-ALG000B00
LoRa gateway dongle 433MHz ~ 510MHz
Safety Instructions
1.
Read these safety instructions carefully.
2.
Keep this User Manual for later reference.
3.
Keep this equipment away from fire.
6.
Do not leave this equipment in an environment unconditioned where the storage
temperature under -40° C (-40° F) or above 85° C (185° F), it may damage the
equipment. Operating temperature: -30°C~70°C.
8.
Do not operate this equipment in an environment temperature may over
70°C(149° F). The surface temperature of plastic chassis may be hot.
9.
All cautions and warnings on the equipment should be noted.
12.
If the equipment is not used for a long time, stop recording by setting utility.
13.
Never pour any liquid into an opening. This may cause fire or electrical shock.
14.
Never open the equipment. For safety reasons, the equipment should be
opened only by qualified service personnel.
15.
If one of the following situations arises, get the equipment checked by service
personnel:
„
The power cord or plug is damaged.
„
Liquid has penetrated into the equipment.
„
The equipment has been exposed to moisture.
„
The equipment does not work well, or you cannot get it to work according to
the user's manual.
„
The equipment has been dropped and damaged.
„
The equipment has obvious signs of breakage.
16.
CAUTION: The computer is provided with a battery-powered real-time clock cir- cuit.
There is a danger of explosion if battery is incorrectly replaced. Replace only with
same or equivalent type recommended by the manufacture. Discard used batteries
according to the manufacturers instructions.
17.
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
18.
CAUTION: Always completely disconnect the power cord from your chassis
whenever you work with the hardware. Do not make connections while the power
is on. Sensitive electronic components can be damaged by sudden power surges.
19.
CAUTION: Always ground yourself to remove any static charge before touching the