Chapter 4 Networking Communication
34
4. Use a twisted-pair UTP or STP cable (category 3, 4, 5) to connect
the TPC-650 through its RJ-45 port to a hub (or a switch) within the
Ethernet LAN to which your host PC is also connected.
5. Assign valid IP addresses for your TPC-650 and host PC. If you are
joining an existing Intranet, ask your network administrator for
valid IP addresses. If you are using a DHCP server on the network,
you need not assign IP addresses yourself.
Note:
To assign IP addresses to your computers, just
access the
Start/Settings/Control Panel/Network
menu, and enter valid IP addresses for each comput-
er.
Note:
If your network is using a DHCP server for dynamic
IP address assignment, you need not assign new
addresses yourself. The IP addresses will be auto-
matically assigned to each networking device once it
is connected to the network.
6. Enter the device name for your TPC-650 for
network identification
.
Note:
To assign a
device name
to your TPC-650, just
access the
Start/Settings/Control Panel/Network
menu, and enter the device name for your TPC-650.
You have to reboot your system to make the device
name viable on the network.
7. After properly establishing the IP status and the device name of
your machine on the network, you must reboot to make the settings
viable on the network.
8. After rebooting is complete, verify that your TPC-650 is function-
ing within the network.
Summary of Contents for TPC-650
