POC S198 User Manual
26
5.1
General Safety Guide
For your own safety and that of your equipment, always take the following precau-
tions.
Disconnect the power plug (by pulling the plug, not the cord), from your computer if
any of the following conditions exists:
The power cord or plug becomes frayed or otherwise damaged
You spill something into the case
Your computer has been dropped or the case has been otherwise damaged
You suspect that your computer needs service or repair
You want to clean the computer or screen
You want to remove/install any parts
5.2
Protecting Your Optical Drive
To keep your optical drive working properly:
Position your computer so that the drive tray doesn't bump into anything when it
opens.
Close the drive when you're not using it.
Do not put anything on the drive tray when it is open.
Do not touch the optical drive lens with your fingers. Do not wipe the lens with a
paper towel or other abrasive surface.
5.3
Thermal
The vent hole of the POC-S198 rear cover functions as a cooling air flow inlet and
outlet. These air inlets and outlets transfer heat from inside the computer to the
cooler air outside. Do not block these holes/vents with any soft material.
When using your POC-S198 system, it is normal for the rear metal heatsink to get
warm. The rear metal heatsink of the POC-S198 functions as a cooling surface that
transfers heat from inside the computer to the cooler air outside. Do not block this
heatsink with any soft material.
Warning! Do not place your POC-S198 system on a pillow or other soft material
when it is on, as the material may block the airflow and cause the com-
puter to overheat.
5.4
Disconnect the Power
The only way to disconnect power completely is to unplug the adapter power cord.
Make sure at least one end of the power cord is within easy reach so that you can
unplug the computer when you need to.
Warning! Your AC cord came equipped with a three-wire grounding plug (a plug
that has a third grounding pin). This plug will fit only a grounded AC out-
let. If you are unable to insert the plug into an outlet because the outlet is
not grounded, contact a licensed electrician to replace the outlet with a
properly grounded outlet. Do not defeat the purpose of the grounding
plug.
Summary of Contents for POC-S198-25F-ACE
