Advantech PCM-9570, Startup Manual

Page: 3 / 4

PCM-9570/S Startup Manual 3
J7: PanelLink control
Open Closed
1-2 Falling-edge latch* Rising-edge latch
3-4 Pixel/clock* 2 pixels/clock
J9: Buzzer enable/disable
Pins Result
Closed Buzzer enabled
Open Buzzer disabled
J10: COM2 RS-232/422/485 select
RS-232* RS-422 RS-485
1-2 Open Open Closed
3-4 Open Closed Open
5-6 Closed Open Open
7-9 Closed Open Open
8-10 Closed Open Open
9-11 Open Closed Closed
10-12 Open Closed Closed
13-15 Closed Open Open
14-16 Closed Open Open
15-17 Open Closed Closed
16-18 Open Closed Closed
J11: ATX power on function select
1-2 +5 V*
2-3 ATX standby 5 V
J12: LAN controller power select
1-2 Default off*
2-3 Default on
*default setting
SW1: Panel type select
Pin
Panel Type
1 2 3 4 5 6
0 0 0 0 0 NC TFT 640 x 480 18 bits
0 X 0 0 0 NC TFT 800 x 600 18 bits
0 0 X 0 0 NC TFT 1024 x 768 24 bits
0 X X 0 0 NC TFT 1024 x 768 36 bits
0 0 0 0 X NC STN 640 x 480 16 bits
0 X 0 0 X NC STN 800 x 600 16 bits
0 0 X 0 X NC STN 1024 x 768 16 bits
0 X X 0 X NC STN 1024 x 768 24 bits
Locating Connectors
PCM-9570/S connectors (solder side)
Note: If the "1" in SW1 is in the OFF position, the
LCD is disconnected.
PCM-9570/S connectors (component side)