1 Startup Manual
Packing List
Before installation, please make sure that you have:
• 1 x Filter Board
• 2 x Screws
• 1 x Pair of Tweezers
If anything is missing or damaged, contact your
distributor or sales representative immediately.
Diagram
Notes
For more information on this and other Advantech
products, please visit our websites at:
http://www.advantech.com
For technical support and service:
http://www.advantech.com/support/
This startup manual is for PCL-8811.
Part No: 2003881100
1st Edition
May 2015
ST
AR
TUP MANUAL
Features
PCLD-8811
Low-Pass Active Filter Board
General Specifications
• The low-pass active filter has the flattest frequency
response as possible in the passband
• 8 set of low-pass Frequencies form 10Hz up to 40KHz
• 2 single-ended or 1 differential AI inputs
• Offset and gain calibration
General
• Connectors
2 x 5 pin male Connectors
• Dimensions
80 x 56 mm
• Filter Type
Active Filter - Butterworth
• Offset Error
± 1 LSB ( LSB resolution refer to
taken DAQ spec. )
• Gain Error
± 1 LSB ( LSB resolution refer to
taken DAQ spec. )
• Filter Frequency
-3dB,10Hz, 50Hz,100Hz, 500Hz
1KHz, 5KHz, 10KHz,40KHz
• Max. Input Voltage ± 10 V
• Input Impedance 1G
Ω
/ 2pF
• Operating Temp.
0 ~ 60°C (32 ~ 140°F)
• Storage Temp
-20~ 70°C (-4 ~ 158°F)
Getting Started
Before you can use the PCLD-8811, you must enable
filter function on PCLD-8810 (please refer to PCLD-
8810 Startup manual) and you can refer to the below
table to set up the cut-off frequency.
1. Plug the PCLD-8811 onto the PCLD-8810
2. Screw the pillars to the cylinders.
Note
: Ensure that the pillar is aligned to the cylinder.
