3 PCE-7131/5131/5031 Startup Manual
H/W monitor alarm (JOBS1)
Function
Jumper Setting
Closed
Enable OBS alarm (Default)
Open
Disable OBS alarm
JWDT1: Watchdog timer output option
Closed Pins
Result
1-2
Reserved
1
2
3
Board Layout
Software Installation
2-3
System reset (Default)
The drivers for the PCE-7131/5131/5031 are located on the
software installation CD. Please click through the folder and
Follow the on-screen instructions.
Caution!
The computer is supplied with a battery-powered
real-time clock circuit. There is a danger of
explosion if the battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer. Discard
used batteries according to the manufacturer’s
instructions.
This device complies with the requirements in Part 15 of
the FCC rules. Operation is subject to the following two
conditons:
1. This device may not cause harmful interference;
2. This device must accept any interference received,
including interference that may cause undesired opera-
tion.
Jumpers and Connectors (Cont.)
Figure 1: Board Layout: Jumper and Connector Locations
Note:
*PCE-5031 supports 4 SATA ports (SATA0~4) and one internal USB3.0 pin-header.
*PCE-5031 doesn’t feature NGFF(M.2).
*PCE-5031 supports 1 DP port.
CPUFAN1
JCASE1
SYSFAN1
JFP1~3
BAT2 DIMMA1
DIMMB1
SPI_CN1
SATA1~5
USB3H2
USB3H3
USB3H1
LANLED1
JOBS1
JWDT1
USB3C1
CPU1
DP2
DP1
SATA0
M.2
COM1
PCH1
COM2
GPIO1
LPC1
HDAUDIO1
KBMS2
Declaration of Conformity
Closed Open
