2 PCA-6011 Startup Manual
Jumpers and Connectors
The board has a number of connectors and jumpers that
allow you to configure your system to suit your application.
The table below lists the function of each of the connectors
and jumpers.
Connectors
Label
Function
IDE1
IDE connector
FDD1
Floppy drive connector
LPT1
Parallel port
VGA1
VGA connector
DVI1
DVI connector (DVI cable is required, P/N
1700008822-11)
COM12
RS232 serial ports connector
KBMS1
PS/2 keyboard and mouse connector
KBMS2
External keyboard/mouse connector
JIR1
Infrared connector
JOBS1
HW Monitor Alarm
Close: Enable OBS Alarm
Open: Disable OBS Alarm
CPUFAN1
CPU1 FAN connector
JFP1
Power and Reset Button connector
JFP2
HDD LED/Speaker connector
JFP3
Power LED and keyboard lock connector
LAN1
LAN RJ45 connector
LANLED1
LAN1 LED connector
HDAUD1
HD Audio connector
SATA1
Serial ATA1
SATA2
Serial ATA2
SATA3
Serial ATA3
SATA4
Serial ATA4
USB12
Two USB port pin headers
USB34
Two USB port pin headers
USB56
Two USB port pin headers
USB78
Two USB port pin headers
DIMMA1
Memory connector channel A
DIMMB2
Memory connector channel B
LPC1
Low pin count connector
SPI1
BIOS SPI Interface
JCASE1
Case open
ATX12V1
Power connector
ATXF1
ATX power connector
GPIO1
GPIO connector
SMBUS1
SMBUS connector
Jumpers
Label
Function
CMOS1
CMOS clear
JWDT1
Watchdog timer output selection
CMOS1: CMOS clear function
Closed Pins
Result
1-2
Keep CMOS data *
2-3
Clear CMOS
JWDT1: Watchdog timer output option
Closed Pins
Result
1-2
IRQ11
2-3
System reset *
Software Installation
The CD disc contains a driver installer program that will lead
you through the installation of various device drivers needed
to take full advantage of your CPU card.
Caution
The computer is provided with a battery-powered real-time
clock circuit. There is a danger of explosion if battery is
incorrectly replaced. Replace only with same or equivalent
type recommended by Advantech. Discard used batteries
according to manufacturer’s instructions.
Safety Information
This device complies with the requirements in Part 15 of
the FCC rules. Operation is subject to the following two
conditions.
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired opera-
tion.
Jumpers and Connectors (Cont.)
1
2
3
* default setting
1
2
3
* default setting