39
3.6.3 Onboard Super IO Device
Press enter to set up the on board super I/O device.
3.6.3.1 Onboard FDC Controller
When enabled, this field allows you to connect your floppy disk
drives to the onboard floppy disk drive connector instead of a separate
controller card. If you want to use a different controller card to connect
the floppy disk drives, set this field to Disabled.
3.6.3.2 Onboard Serial Port 1 (3F8H/IRQ4)
The settings are 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, and
Disabled for the on-board serial connector.
3.6.3.3 Onboard Serial Port 2 (2F8H/IRQ3)
The settings are 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, and
Disabled for the on-board serial connector.
3.6.3.4 UART 2 Mode Select
This item allows you to select UART mode.
3.6.3.6 Onboard Parallel Port (378H/IRQ7)
This field sets the address of the on-board parallel port connector
You can select either 3BC/IRQ7, 378/IRQ7, 278/IRQ5 or Disabled. If
you install an I/O card with a parallel port, make sure there is no conflict
in the address assignments. The CPU card can support up to three parallel
ports, as long as there are no conflicts for each port.
Summary of Contents for PCA-6005-B
