![Advantech MIOe-DB5000 User Manual Download Page 11](http://html1.mh-extra.com/html/advantech/mioe-db5000/mioe-db5000_user-manual_2857842011.webp)
3
MIOe-DB5000 User Manual
Chapter 1
C
onnector,
Jumper
and
S
witch Setting
1.3
Placement
1.4
Jumpers
1.4.1
Jumper Description
Cards can be configured by setting jumpers. A jumper is a metal bridge used to close
an electric circuit. It consists of two metal pins and a small metal clip (often protected
by a plastic cover) that slides over the pins to connect them. To close a jumper, you
connect the pins with the clip. To open a jumper, you remove the clip. Sometimes a
jumper will have three pins, labeled 1, 2 and 3. In this case you would connect either
pins 1 and 2, or 2 and 3.
The jumper settings are schematically depicted in this manual as follows.
A pair of needle-nose pliers may be helpful when working with jumpers. If you have
any doubts about the best hardware configuration for your application, contact your
local distributor or sales representative before you make any changes.
Generally, you simply need a standard cable to make most connections.
CN1
CN2
CN3
CN4
CN5
CN6
CN7
CN8
CN25
CN10
CN17
CN15
CN13
CN14
CN18
CN9
CN19
CN16
CN21,CN22
CN20
CN11
CN12
Warning! To avoid damaging the computer, always turn off the power supply
before setting jumpers.