2 MIC-7700 Startup Manual
Physical Characteristics
•
Dimensions (WxHxD):
77 x 192 x 230 mm
•
Weight:
2.8 kg (6.17 lbs)
The board has a number of jumpers that allow you to con-
figure your system to suit your application. The table below
lists the function of each of the jumpers and connectors.
Connectors
Label
Function
VGA1
VGA Connector
DVI1
DVI connector
COM 12
RS-232/422/485
COM 34
RS-232
USB 12
USB 3.0
USB 34
USB 3.0
USB 5678 USB3.0 (Q170) or USB2.0 (H110)
LAN 1
Intel i219LM (Q170) or Intel i219V (H110)
LAN 2
Intel i210IT
Audio
Audio Jack (Line-out, Mic-in)
LED 1234 COM 1/2 TX; RX; LED
LED 5
Storage device status
DC 9-36V Power connector
1
2
3
1
2
3
AT Module ATX Module
PSON1: System AT/ATX Module Selection
Function
Jumper Setting
1-2
AT module
2-3
ATX module (Default)
The drivers for the MIC-7700 are located on the software
installation CD. Please click through the folder and follow
the on screen instructions to install them.
The computer is supplied with a battery-powered realtime
clock circuit. There is a danger of explosion if battery is
incorrectly replaced. Replace only with same or equivalent
type recommended by the manufacturer. Discard used bat-
teries according to manufacturer’s instructions.
This device complies with the requirements in Part 15 of
the FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference;
2. This device must accept any interference received,
including interference that may cause undesired
operation.
Memory Installation
MIC-7700 supports DDR4 SO-DIMM non-ECC type
memory module. If you needs detail memory support list,
please contact your distributor or sales representative to
order compatible memory modules.
1
1
1
1
2
2
2
4
3
3
USB 3.0/2.0
LAN1/2
COM 1/2
CFast Socket
Power
9 -36VDC
Line-out
Mic-in
COM 3/4
DVI
VGA
COM1
TX/RX
COM2
TX/RX
Specifications (Cont.)
Declaration of Conformity
System I/O Interface
Simple Maintenance Process
Jumpers and Connectors
Software Installation
