MIC-3329 User Manual
8
1.4
Jumpers and Switches
Table 1.4 lists the jumper and switch functions. Refer to this section carefully before
changing the jumper and switch settings on your MIC-3329 board.
Figures 1.4 through 1.6 illustrate jumper and switch locations.
The MIC-3329 provides a system reset button on the front panel, it resets all payload
and application-related circuitry.
Figure 1.5 MIC-3329 Front 4HP Board Jumper Locations
Table 1.3: MIC-3329 Switch Descriptions
Board
Position
Description
Default Setting
MIC-3329
Front 4HP
Board
CN3
Battery pin head
SW1
DIP Switch for setting LAN1/2 and
VGA as front or rear
Front VGA/LAN1 LAN2
MIC-3329
Front 8HP
XTM Board
SW3/SW4
DIP Switch for COM 232/422/485
setting (4 code for SP338)
Default setting RS232;
RS422/RS485 setting refer
to silkscreen on PCB top
side
SW5/SW6/
SW7/SW8
Control COM workable or not
Always setting "ON", refer
to PCB bottom side
MIC-3329
RIO 8HP
XTM Board
SW3/SW4
DIP Switch for COM 232/422/485
setting (4 code for SP338)
Default setting RS232;
RS422/RS485 setting refer
to silkscreen on PCB top
side
Summary of Contents for MIC-3329 Series
