Advantech IPC-7220, User Manual, Page: 15 / 42

Figure 2-3 Installing the drives
2.4 Installing plug-in cards
The IPC-7220 can accept up to seven plug-in cards. To install a plug-in
card, please refer to Figure 2-4 and proceed as follows:
1. Remove the two screws, which mount the hold-down clamp to
the chassis, then take out the hold-down clamp.
2. Find the slot(s) which is go to be inserted a card(s), and remove
the slot’s blank bracket(s) attached to the rear plate of the
chassis.
3. Insert a plug-in card. Make sure that the card bracket has been
inserted properly and the other edge of the card has been fixed
in the guide rail. Fasten the card at the top of the bracket with a
screw.
4. Repeated Step 3 if there is more than one card.
5. Insert the rubber buffers into the hold-down clamp, which is
attached to the power supply bracket. Buffers cushion plug-in
cards from shock and vibration. The hold-down clamp has two
rows of notches for the rubber buffers to be inserted, one row is
for PCI cards, the other row for ISA cards. Depending on the
card height, the buffers can be inserted as the narrow end face
upwards or downwards.
6. After inserting the rubber buffers, return the hold-down clamp
and fasten it with screws.
11