Advantech GMB-910, User Manual

Page: 20 / 80

GMB-910 User Manual 12
1.11.4 Removing a DDR2 DIMM
1.12 Expansion Slots
In the future, you may need to install expansion cards. The following subsections
describe the slots and the expansion cards that they support.
1.12.1 Installing an Expansion Card
1. Before installing the expansion card, read the documentation that came with it
and make the necessary hardware settings for the card.
2. Remove the system unit cover (if your motherboard is already installed in a
chassis).
3. Remove the bracket opposite the slot that you intend to use. Keep the screw for
later use.
4. Align the card connector with the slot and press firmly until the card is com-
pletely seated on the slot.
5. Secure the card to the chassis with the screw you removed earlier.
6. Replace the system cover.
1.12.2 Configuring an Expansion Card
After installing the expansion card, configure it by adjusting the software settings.
1. Turn on the system and change the necessary BIOS settings if any.
2. Assign an IRQ to the card if needed. Refer to the tables on the next page.
3. Install the software drivers for the expansion card.
1. Simultaneously press the retain-
ing clips outward to unlock the
DIMM.
2. Remove the DIMM from the
socket.
Caution! Support the DIMM lightly with your fingers when pressing the ejector
tabs. The DIMM might get damaged when it flips out with extra force.
Warning! Make sure to unplug the power cord before adding or removing expan-
sion cards. Failure to do so may cause you physical injury and damage
motherboard components.