3.1 CD-ROM drive
To insert a CD-ROM disc, press the eject button of the CD-ROM drive. The yellow activity light
will flash and the front panel will come out a short distance. Using your fingertips, hold the top
and bottom of the front panel and pull it outward to the very end. Align the center hole of the
CD-ROM disc with the center circle of the CD-ROM holding plate. Press the transparent ring
around the center hole of the CD-ROM until you hear a click. Push the front panel of the
CD-ROM drive back to its original place.
To eject a CD-ROM disc, first ensure that the drive activity light is off. Then press the eject
button on the drive. When the disc pops out of the drive, remove it and store it properly.
3.2 PS/2mouse & keyboard
If you wish to use a full-size desktop keyboard and PS/2 mouse with your panel PC, follow
these instructions:
1. Be sure the panel PC is turned off.
2. Connect the PS/2 mouse and keyboard on the port on the rear bottom side of the rear cover.
3. Turn on the panel PC.
3.3 PCI Bus Expansion
The panel PC supports PCI bus expansion cards. To integrate a new PCI bus card into your
system, follow these instructions:
1. Turn off the panel PC.
2. Unscrew the 6 screws on the rear cover, and remove this cover.
3. Remove the metal plate by unscrewing the attaching screw.
4. Insert the PCI bus card into the PCI slot of the riser card.
5. Run the setup program within your operating system to configure your system.
3.4 Parallel port
The panel PC supports the latest EPP and ECP parallel port protocols for improved
performance and versatility with compatible printers or other devices.
To connect the panel PC to a printer or other devices:
1. Be sure both the panel PC and the printer/devices are turned off.
2. Connect the 25-pin male connector of the printer cable to the 25- pin female port on the
panel PC labeled "parallel port".
3. If necessary, attach the other end of your printer cable to your printer, and fasten any
retaining screws.
4. Turn on the printer and any other peripheral devices you may have connected to the panel