Advantech EKI-1228-DR Series, User Manual, Page: 28 / 64

18 EKI-1228-DR Series User Manual
5. Tighten the wire-clamp screws to secure the DC wires in place.
Figure 2.18 Installing DC Wires in a Terminal Block
6. Align the terminal block over the terminal block receptor on the switch.
7. Insert the terminal block and press it in until it is flush with the terminal block
receptor.
8. Tighten the screws on the terminal block to secure it to the terminal block
receptor.
If there is no gap between the terminal block and the terminal receptor, the
terminal block is seated correctly.
Figure 2.19 Securing a Terminal Block to a Receptor
2.3 Reset Button
Reset configuration to factory default:
Press and hold Reset button for 10 seconds.
System reboot:
Press and hold Reset button for 2 seconds.
Loosening
Wire-clamp
Screws
Installing DC
Wires
Securing
Wire-
clamp Screws
Note! Do NOT power off the Ethernet switch when loading default settings.