21
SPC-800(M) User Manual
C
ha
pte
r 2
Sy
ste
m
S
etu
p
2.2
System Setup
SPC-800(M) devices install Cover IO
1.
The Base Unit standard product contains SPC-800 device, Cover IO and ARM
screws.
Fix 2 pcs with M5 x 10 screws on the Cover IO screw hole location (Do not fas
-
ten screw)
2.
Place Cover IO to product and fasten 2pcs Screws.
3.
Fix 2 pcs with M5 x 10 screws on the other Cover IO screw hole location
The following figure shows an example.
2.3
Mounting the SPC-800(M) device
The section describes the mounting of the device to a support ARM or VESA system
using example figures.SPC-815 and SPC-821 are the same design and same com
-
ponent for Pendant and Pedestal mounting.(no additional component is needed) And
VESA mount is optional. We use icoteck German vendor for Cable Entry and design
100 x 100mm standard VESA compliant hole to allow wall and accessory mounting
option.
Warning!
Make sure that fasteners are adequately dimensioned during installa
-
tion. Make sure to consider the weight of the device and the forces act
-
ing on the device when dimensioning.
Inadequately dimensioned fasteners or insufficient lock may cause the
device to fall down. Serious physical injury may result.
The device must be mounted securely.
Summary of Contents for BOR-DE Series
