Advantech AIMB-740-6CB1, User Manual

Page: 112 / 158

AIMB-740-B/741-B User’s Manual 98
Appendix A Programming the watchdog
timer
A.1 Programming the Watchdog Timer
The AIMB-740-6CB1's watchdog timer can be used to monitor system
software operation and take corrective action if the software fails to func-
tion after the programmed period. This section describes the operation of
the watchdog timer and how to program it.
A.1.1 Watchdog timer overview
The watchdog timer is built-in the super I/O controller W83627HF. It
provides the following functions for user programming:
• Can be enabled and disabled by user's program
• Timer can be set from 1 to 255 seconds or 1 to 255 minutes
• Generates an interrupt or resets signal if the software fails to reset the
timer after time-out
A.1.2 Reset/ Interrupt selection
The J2 jumper is used to select reset or interrupt (IRQ 11) in the event the
watchdog timer is tripped. See Chapter 1 for detailed jumper settings.
Note: The interrupt output of the watchdog timer is a low level
signal. It will be held low until the watchdog timer is
reset.
A.1.3 Programming the Watchdog Timer
The I/O port address of the watchdog timer is 2E (hex) and 2F (hex).
2E (hex) is the address port. 2F (hex) is the data port.
You must first assign the address of register by writing address value
into address port 2E(hex), then write/read data to/from the assigned
register through data port 2F (hex).