AIMB-256 User Manual
16
1.5.4
Removing a DDR2 DIMM
1.
Press the two ejector tabs on the slot outward simultaneously, and then pull out
the DIMM module.
1.6
Expansion Slots
In the future, you may need to install expansion cards. The following sub-sections
describe the slots and the expansion cards that they support.
1.6.1
Installing an Expansion Card
1.
Before installing the expansion card, read the documentation that came with it
and make the necessary hardware settings for the card.
2.
Remove the system unit cover (if your motherboard is already installed in a
chassis).
3.
Remove the bracket opposite the slot that you intend to use. Keep the screw for
later use.
4.
Align the card connector with the slot and press firmly until the card is com-
pletely seated on the slot.
Caution!
Support the DIMM lightly with your fingers when pressing the ejector
tabs. The DIMM might get damaged if it flips out with extra force.
Warning!
Make sure to unplug the power cord before adding or removing expan-
sion cards. Failure to do so may cause you physical injury and damage
motherboard components.
Summary of Contents for AIMB-256
