Advantech AIMB-230, User Manual

Page: 26 / 96

AIMB-230 User Manual 14
2.1 Introduction
You can access most of the connectors from the top of the board as it is being
installed in the chassis. If you have a number of cards installed or have a packed
chassis, you may need to partially remove the card to make all the connections.
2.2 LAN Ports and USB Ports (LAN1, LAN2, USB12,
USB34, USB56)
The AIMB-230 provides up to six USB ports. Four USB3.0 on the real side and two-
pin header on the board. The USB interface complies with USB Specification Rev.
2.0 and Rev. 3.0 supporting transmission rate up to 625 Mbps and is fuse protected.
The USB interface can be disabled in the system BIOS setup.
The AIMB-230 is equipped with two high-performance 1000 Mbps Ethernet LAN
adapter, both of which are supported by all major network operating systems. The
RJ-45 jacks on the rear panel provide for convenient LAN connection.
Front Panel LAN LED(LANLED1)
Table 2.1: LAN LED Indicator
LAN Mode LAN Indicator
LAN1 indicator
LED1 (Right) off for mal-link; Link (On) / Active (Flash)
LED2 (Left) 100 Mbps (On) / 10 Mbps (Off)
LED2 (Left) 1000 Mbps (On)
LAN2 indicator
LED1 (Right) off for mal-link; Link (On) / Active (Flash)
LED2 (Left) 100 Mbps (On) / 10 Mbps (Off)
LED2 (Left) 1000 Mbps (On)
LAN1 LAN2 USB12 USB34