4 AGS-923 StartupManual
/AGS-923快速入门手册/AGS-923快速入門手冊
2. Mount the chassis (inner) member to the chassis.You
may opt for M4 or M5 pan head screw. The screw head
of either M4 or M5 can not exceed 2.0 mm. Alterna-
tively, you may mount the slide member to the chassis
through standoffs. Likewise, the head of stand-off can
not exceed 2.0 mm. Each side of chassis is highly
suggested to use 3 of screws or standoffs for slide
attachment.
3. Attach the cabinet (outer) member to the rail.
Insert the stag into the upper and lower square holes
on EIA rail from the back of rail. Push the safety lock
forward to secure the bracket. It is important to check if
the safety lock is in unlocked position before mounting
the brackets.
4. Mount the chassis into the cabinet.
Insert the chassis (inner) member into the cabinet
member as shown on the drawing. It is important to
check if the ball retainer is in fully open position before
install the chassis. It might cause catastrophic damage
to the chassis if ball retainer is not in fully open position
while mounting the chassis. While you are pushing
chassis back to the cabinet, you need to release the
slide from locking position by pressing the trigger down.
1. Read these safety instructions carefully.
2. Keep this User Manual for later reference.
3. Disconnect this equipment from any AC outlet before
cleaning. Use a damp cloth. Do not use liquid or spray
detergents for cleaning.
4. For plug-in equipment, the power outlet socket must
be located near the equipment and must be easily
accessible.
5. Keep this equipment away from humidity.
6. Put this equipment on a reliable surface during installa-
tion. Dropping it or letting it fall may cause damage.
7. The openings on the enclosure are for air convection.
Protect the equipment from overheating. DO NOT
COVER THE OPENINGS.
8. Make sure the voltage of the power source is correct
before connecting the equipment to the power outlet.
9. Position the power cord so that people cannot step on
it. Do not place anything over the power cord.
10. All cautions and warnings on the equipment should be
noted.
11. If the equipment is not used for a long time, disconnect
it from the power source to avoid damage by transient
overvoltage.
12. Never pour any liquid into an opening. This may cause
fire or electrical shock.
13. Never open the equipment. For safety reasons, the
equipment should be opened only by qualified service
personnel.
14. If one of the following situations arises, get the equip-
ment checked by service personnel:
- The power cord or plug is damaged.
- Liquid has penetrated into the equipment.
- The equipment has been exposed to moisture.
- The equipment does not work well, or you cannot get
it to work according to the user’s manual.
- The equipment has been dropped and damaged.
- The equipment has obvious signs of breakage.
15. Do not leave this equipment in an environment where
the storage temperature may go below 0° C (32° F) or
above 40° C (104° F). This could damge the equipment.
The equipment should be in a controlled environment.
16. CAUTION: DANGER OF EXPLOSION IF BATTERY IS
INCORRECTLY REPLACED. REPLACE ONLY WITH
THE SAME OR EQUIVALENT TYPE RECOMMENDED
BY THE MANUFACTURER, DISCARD USED BAT-
TERIES ACCORDING TO THE MANUFACTURER’S
INSTRUCTIONS.
17. THE COMPUTER IS PROVIDED WITH CD DRIVES
COMPLY WITH APPROPRIATE SAFETY STANDARDS
INCLUDING IEC 60825.
18. This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference.
System Setup
/系统安装/系統安裝
Safety Instructions
/安全指示
