Advantech ACP-7000, User Manual

Page: 29 / 52

19 ACP-7000 User Manual
Chapter 3
O
peration
3.4 Replacing the Power Supply
The ACP-7000 supports various power supply models. To replace the power supply
module, please proceed as follows:
1. Turn off the failed power supply module.
2. Loosen the screw on the failed module and then gently pull the module out by
the handle (see
Figure 3.7-a and Figure 3.7-b ).
3. Make sure that the new power supply module is the same rating as the currently
installed one.
4. Slide the power supply module inward until it locks into position, then tighten the
screws.
5. Return the handle to its original place.
(a) power supply module of 460 W
(b) power supply module of 570 W / 810 W
Figure 3.7 Replacing the power supply module