Advanced Operational Functionality:
• Recording audio messages using the on-board call box microphone. The call box MUST be in ‘Sleep
Mode’ when the following steps are started:
1.
Press the ‘Activate’ and ‘Reset’ buttons simultaneously until the status LED flashes two times.
2.
Press the ‘Activate’ button one time. A beep will be heard from the local speaker.
3. Additional presses of the activate button will step through the available message numbers, 1
through 16. (See default message list in
“Notes”
below)
4.
Press the ‘Activate’ button until the desired message number has been selected.
5.
Press the reset button to start recording.
• Speak clearly into the call box microphone.
• When the message is complete, press the reset button again to stop recording.
NOTE:
Pressing the reset button a second time at this point will enter local speaker ‘Volume Set’
mode. See
“Adjusting the Volume Level …”
below for volume set details.
6.
Press the ‘Activate’ button to remain in record mode. A beep will be heard.
7.
Press the Activate button to select the next audio message number to record.
8. Repeat step 5 through 7 above for all desired audio messages.
9. To exit audio recording mode, press and hold the reset button until the status LED flashes red one
time.
10.
The call box enters “sleep mode”.
Notes:
When recording messages, speak clearly at approximately 6 to 12 inches from the call box
microphone.
A slight pause after pressing the reset button to start the recording is recommended.
Default message numbers:
Message 1 – Speaker message on activation
Message 2 – Transmit message on activation
Message 3 – Speaker message on clear
Message 4 – Transmit message on clear
Message 5 – Low battery alert
•
Adjusting the volume level of the call box local speaker. The call box MUST be in ‘Sleep Mode’ when
the following steps are started:
1.
Press the ‘Activate’ and ‘Reset’ buttons simultaneously until the status LED flashes two times.
2.
Press the reset button one time. A beep will be heard from the local speaker.
3. Additional reset button presses will increment the volume level up, activate button presses will
increment the volume level down.
Note:
There are 16 volume levels. 1 is the lowest, 16 is the highest.
4.
To exit volume adjust mode, press and hold the Reset button until the status LED flashes red one
time.
5.
The call box enters “Sleep Mode”.
•
Test the One-way call box. Press the Activate button to confirm desired audio messages and local
speaker volume. Press the Reset button to confirm desired audio messages.
