Clock Installation Instructions
(IPCSS-RWB/IPCSL-RWB/IPSIGNL-RWB)
Version 1.5
4/20/2015
For additional support, visit
www.anetdsupport.com
Boot Sequence
When first powered, if properly installed, the device should boot and then display the
time, as follows:
1
Boot sequence
This is the 1st screen seen, and you will hear the AND
jingle during it. This screen should come on within 1-2
seconds of powering on the device.
2
This indicates the current firmware the device is
equipped with.
3
The network MAC address of the device. This is
configured at the factory.
4
The device is now looking for a DHCP server among
other things.
If it hangs in this state, there is a good
chance there is a network problem (cable, switch, ISP,
DHCP, etc.
).
5
The IP address of the device. This is network specific,
and depends what DHCP assigns it or static if configured
as such. You should hear an audio beep during this
stage.
6
Once all initialization is done, the time will be displayed.
If just a colon is displayed, it is alive, but cannot find the
time. Check the NTP server settings and check that the
internet connection is working.
Troubleshooting and Other Tips
Startup Questions:
http://www.anetdsupport.com/faqs/startup-questions
Tips/Tricks:
http://www.anetdsupport.com/faqs/general-questions
Troubleshooting:
http://www.anetdsupport.com/faqs/troubleshooting
Complete support site with user guides and help:
http://www.anetdsupport.com/
