BASE STATION OPERATION
•
Make sure the second battery pack is in the base station charging receptacle.
•
The LED on the right side of the base station will display the charging status of the
battery, Red is fast charge and Green fully charged.
•
If the battery power drops below sufficient power level, you will notice a slight
increase in background noise. Remove battery pack from the headset and replace it
with a freshly charged battery pack from the base station. Place the discharged
battery pack from the headset into the base station charger.
•
The newly charged battery will have a 4 hour on time
•
Normal charging time for the battery is 2.5 hours.
HEADSET OPERATION
•
During a call, should it be necessary to adjust the receiver volume, push the three step
volume button to achieve the correct level.
•
Transmit and receive range is 5 feet from the base station. If you exceed this range,
the headset will generate an out of range tone every four seconds, up to eight times
for a total of 32 seconds. When you return back into range the headset will still be
linked to the base station. If you stay out of range for more than 32 seconds, the
headset will automatically turn off to conserve battery power. At that time the yellow
LED will be off, indicating a broken link.
•
To establish the link, simply turn the headset back on and the yellow LED will be
back on showing the link has been established.
•
If for some reason you experience some interference with other electronic devices
such as labtop computer TV set or radio etc. you can change the frequency setting by
removing the battery pack from the headset and changing the 2 channel select switch
to the other position.
CAUTION:
•
Do not attempt to put on your headset or change the battery while driving.
•
Only turn off the headset when you leave the car or when you do not wish to use your
cellular phone.
FCC COMPLIANCE STATEMENT:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
CAUTION:
Changes or modifications not expressly approved by the manufacturer responsible for
compliance could void the user’s authority to operate the equipment
