Operation
4-2
Right Hand Control Panel
The right hand control panel looks like the figure below.
Upper Roll Heater Controls:
Two position switch turns heater for upper roll on and off. The
temperature controller allows the operator to set a desired
temperature for the process. The controller will maintain that
temperature during the process.
Lower Roll Heater Controls:
Two position switch turns heater for upper roll on and off. The
temperature controller allows the operator to set a desired
temperature for the process. The controller will maintain that
temperature during the process.
Nip Roll Switch:
This switch will open and close the nip rolls.
Fans
Switch:
This switch turns the web cooling system on and off for web
cooling during thermal lamination.
Drive Control
:
E-Stop
switch will stop the laminator and open the rolls.
Speed Pot
sets the laminators speed. 0-20 FPM
FWD/REV
button toggles the drive between forward and
reverse. If the button is lit the machine is in reverse mode.
STOP
button stops the drive from turning thus stopping the
rolls.
RUN
button switches the laminator from jog mode to run
mode.
Power Control:
Main Power
switch turns on power to the machine. This
switch can be locked in the off position for servicing.
Reset
button resets the machine after an E-stop condition or
at initial startup. Hold button for 15 seconds after turning
main power switch on.
Figure 1 Right Hand Control Panel