Grounding the Pyrometer
If you are using a converter box, make a suitable earth ground connection using a
customer-supplied ground cable as shown in the following figure. This will prevent
transmission interference.
Figure 3‑2. Ground connection for the converter box
Connecting the Sensor Cable
To meet EMC requirements, use a shielded cable. All AE sensor cables are shielded
and will meet this requirement once properly connected to the terminal block on the
converter box.
☞
Important
If the sensor cable wires are extended, the shield of the cable also needs to be
extended.
Feedthrough for cable #2
Cable wires and end sleeves
Washer
O-ring
Shield
Terminal block for cable #2
Terminal block for cable #1
Feedthrough for cable #1
Clamp screw
Sensor cable
BROWN
BLACK
BLUE
BROWN
BLACK
BLUE
Figure 3‑3. Connecting the sensor cable
Advanced Energy
®
Impac
®
Series 600 Pyrometer
57010228-00C
Installation, Setup, and Operation
3‑3
