Advanced Energy HFV 8000, User Manual

Page: 103 / 142

5705211-C Installation, Setup, and Operation 5-9
HFV 8000 Generator
Before Engaging the Rear Circuit Breaker
Become familiar with the Unpacking, Spacing Requirements, and Grounding sections
in this chapter. Also, review the following sections:
• Cooling water: “Connecting Cooling Water” on page 5-5 .
• Output power: “Connecting I/O and Auxiliary Connectors” on page 5-6 .
• Input Power: “Connecting Input Power” on page 5-7 .
Control Port ( Generator User port or DeviceNet port):
• Generator User port: Table 4-1 on page 4-2 .
• DeviceNet port: Table 4-8 on page 4-38 .
Note: If you use the DeviceNet interface, the interlocks still require external
contact closure between pin 11 and pin 12 of the Generator User port.
See Table 4-7 on page 4-20 .
Before Enabling the Output
1. Be sure to complete the steps in “Before Engaging the Rear Circuit Breaker” on
page 5-9 .
2. Make sure the Standby/Stop switch on the front panel is in the Stop (down)
position.
3. Engage the rear circuit breaker.
Note: The front panel display should now activate.
4. Verify the desired regulation mode is selected by looking at the front panel Load
Regulation indicator.
ON = load power regulation mode is selected (this is the default).
OFF = Forward power regulation is selected.
FLASHING = The generator has been set to center frequency mode.
To change the regulation mode, see:
4
Command 12 in Table 4-7 on page 4-20
5. Select the proper frequency band. See “Setting the Frequency Band” on page 5-11
for more information.
Enabling the Output
1. Be sure to have completed the steps listed in “Before Engaging the Rear Circuit
Breaker” on page 5-9 and “Before Enabling the Output” on page 5-9 .