AET63 Reference Manual
version 1.8 September 2006
Advanced Card Systems Ltd.
Page 29 of 29
Appendix C: Technical Specifications
Device
AET63 BioTRUSTKey
Power supply
Power supply ........................................ USB powered
Supply voltage ...................................... Regulated 5V DC
Universal Serial Bus Interface
Type ..................................................... USB v1.1, four lines: +5V, GND, D+ and D-
Power source........................................ From USB
Speed ................................................... 1.5 Mbps (Low Speed)
Smart Card Interface
Standard ............................................... ISO 7816 1/2/3, T=0 and T=1
Supply current....................................... max. 50mA
Smart card read / write speed ............... 9600 – 96000 bps
Short circuit protection ......................... +5V / GND on all pins
The presence of the smart card power supply voltage is indicated through a green LED on the reader
CLK frequency ...................................... 4 MHz
Card connector ..................................... Landing contacts (8 contacts)
Card insertion cycles............................. min. 100,000
Fingerprint Scanner Interface
Power consumption ............................. Active mode : 20mA @ 5V + 105mA @ 3.3V
Sleep mode :< 1mA @ 5V + 70µA @ 3.3V
Active sensor size................................. 12.8 x 18 mm
Array size ............................................. 256 x 360 pixels
Image resolution .................................. 508 DPI
ESD tolerant ........................................ +/- 15kV air discharge
Case
Color..................................................... Silver-gray
Operating Conditions
Temperature ......................................... 0 - 50
°
C
Humidity................................................ 5% - 93%
Standard/Certifications
CE, FCC
OS
Windows 98, ME, NT4, 2K, XP and Linux
OEM
OEM-Logo possible, customer-specific colors
Note
: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause
undesired operation.
Warning
: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.
Consult the dealer or an experienced radio/TV technician for help.
