Supplies and Tools Required
54
Installation and Commissioning Manual
F
S
P
3000R
7 R
11
.1 8000
0015930
Issue
B
, ©
2012
ADVA AG Optical Netw
orking
ADVA Conf
idential
fiber may be included. It is also possible to select services and view their
path through the nodes and components.
•
Channel Allocation Information provided by the FSP NP
The “Channel Allocation” window displays the allocation of channels in a
specific network configuration. Based on the information in the displayed
table, you can identify which stretches (of paths) can re-use wavelengths, if
possible. The channels that have not been allocated yet can also be dis-
played.
•
Statement of Compliance/Acceptance
•
This is an agreement that the equipment has been accepted by the cus-
tomer.
Supplies and Tools Required
This section lists the required supplies and tools you need to install and com-
mission the FSP 3000R7.
It contains the following subsections:
Adaptor Brackets
Usually each shelf comes with 19-inch rackmount brackets pre-installed. If the
shelf is to be mounted into an ETSI or NEBS compliant rack, the appropriate
brackets must be attached to the side panels of the shelf. The ETSI and NEBS
bracket pairs are included in the shipping box. For more information, refer to
Chapter 3: Site Planning and Preparation
.
Dummy Modules
Each unoccupied shelf slot must be filled with an appropriate dummy module.
Two variants are available:
•
DM/5HU (used for populating each 5 HU shelf slot)