Adva FSP 3000R7, Installation And Commissioning Manual, Page: 315 / 378

Chapter 9 Connecting Optical Cables
Installation and Commissioning Manual 315
F
S
P
3000R
7 R
11
.1 8000
0015930
Issue
B
, ©
2012
ADVA AG Optical Netw
orking
ADVA Conf
idential
Connecting the OSCM-V#1630s to the West and
East OSFM+#1630s
To connect the OSCM-V#1630s to the West and East OSFM+#1630 modules,
use the proper cable jumper pairs and the connectors listed in
Table 30 and
Table 31 . Proceed as described in “Procedure” on p. 310 .
FSP 3000R7 ROADM-C40/40/2-3HU-2DC
and FSP 3000R7 Optical Cabling
The following section describes how to establish optical connections between
the FSP 3000R7 master shelf supporting modules and
ROADM-C40/40/2-3HU-2DC shelves.
Network Element Connections
The diagrams below show how a typical NE is internally cabled using
ROADM-C40/40/2-3HU-2DCs. Refer to
Figure 98 , NE Signal Flow Diagram.
The diagram shows typical signal flow through the NE when
ROADM-C40/40/2-3HU-2DCs are connected to the FSP 3000R7 master shelf.
In the diagram, the ROADM-C40/40/2-3HU-2DCs are cabled for adding, drop-
ping and passing through channels. Note that if there is only going to be an add
or drop channel, then the U-D and U-M port connections between the two
ROADM-C40/40/2-3HU-2DC shelves would not be required.
Table 30: Optical Connections OSCM-V#1630 to OSFM+#1630 Running
in West Direction
from OSCM-V#1630 West Optical Cable to OSFM+#1630 West
N-T transmission fiber C-M (C-Rx)
N-R reception fiber C-D (C-Tx))
Table 31: Optical Connections OSCM-V#1630 to OSFM+#1630 Running
in East Direction
from OSCM-V#1630 East Optical Cable to OSFM+#1630 East
N-T transmission fiber C-M (C-Rx)
N-R reception fiber C-D (C-Tx))