Installing the SH9HU, SH7HU, SH7HU-R and 1HU Equipment Shelves
136
Installation and Commissioning Manual
F
S
P
3000R
7 R
11
.1 8000
0015930
Issue
B
, ©
2012
ADVA AG Optical Netw
orking
ADVA Conf
idential
Step 3
Take the ETSI or NEBS brackets out of the plastic bags (as supplied
in the rack-mount kit).
Step 4
Remove the 19-inch bracket on one side panel of the shelf as follows:
a) Using a Torx screwdriver TX20, turn the two screws fixing the
19-inch bracket in counter-clockwise direction until they are
removed from thread holes completely and lay them aside.
b) Remove the bracket and put it aside.
Step 5
Fit the appropriate ETSI or NEBS bracket to the shelf as follows:
a) Place the appropriate bracket on the same side of the shelf in the
correct position as illustrated in
and
. The two
threaded holes in the shelf side panel and the holes of the bracket
should line up.
b) Reinsert the two fixing screws M4x6 into the threaded holes.
c) Secure the bracket to the shelf by tightening the screws with a
Torx screwdriver TX20.
Figure 16:
Fitting an 1HU Shelf with an ETSI Bracket
Figure 17:
Fitting an 1HU Shelf with an NEBS Bracket
Step 6
Save the 19-inch bracket with the packaging material.
Step 7
Repeat
to
for the opposite side.
End of Procedure
ETSI bracket
M 4 x 6 screws
NEBS bracket
M 4 x 6 screws