Adtron I35MB Operations Manual
Rev. 003, PN: 610200094
4
Interface Connectors
The I35MB has an interface connector located on the front panel. Using an 80-
conductor cable (40-pin connector); connect the I35MB to the primary or secondary
ports on the IDE controller. Plug a power cable from the computer’s power supply
into the I35MB power connector. The I35MB does not require 12V. Refer to the
Figure below, for the location 40-pin connector and power supply.
40-pin connector
4-pin Power
connector
Figure 5 I35MB interface
I35MB Installation
Introduction
The I35MB is a 3.5-inch hard disk drive and mounts into a standard 3.5-inch hard
disk drive bay. The drive may be mounted from the side or the bottom.
DO NOT
exceed the maximum insertion depth of 3.8mm [.150”] from drive edge.
Consider the length of the screw used and thickness of the mounting surface. A
common screw length of 3/16” is provided, but may not be correct in all
applications.
Refer to Figure 6 on page 5 for mounting hole locations.
Static Sensitive
- The I35MB is a static sensitive device. When installing
and uninstalling the I35MB, take precautions to ensure that static does not
discharge into the I35MB.
