ADTRAN TOTAL ACCESS 600R, System Manual

Page: 125 / 196

Total Access 600R System Manual Section 4 User Interface Guide
61200600L1-1A © 2002 ADTRAN, Inc. 125
Appendix B. Configuring the Unit for Bridging
Initial Setup
Before the unit can be configured for bridging, DS0s must be mapped. Reference the DS0 Mapping section
on page 119.
Setting up Bridging Options
If the unit will be used for bridging, continue with the steps below.
Bridging
Bridging is supported by the PPP and Frame Relay protocols. The following procedures describe the
bridging configuration for those two protocols.
PPP Bridging Setup Instructions
1
From the Main menu, select L2 P
ROTOCOL
(T1[0])>P
ROTOCOL
and select
PPP .
2 Select C
ONFIG
and press <Enter> . Then select M
ODE
and select B
RIDGE
A
LL
.
3 Use the left arrow to return to the Main menu; select B
RIDGE
.
4
The user may confirm that Bridging is activated by selecting C
ONFIG
and
I
NTERFACES
. If the T1[0] interface appears in the list, the Bridging is active on
the WAN link.
5
The time (in minutes) it takes an entry to age out of the Bridge table may be
set by down arrowing to
B
RIDGE
T
ABLE
and then using the right arrow to select
B
RIDGE
T
ABLE
A
GING
.